Toro service manual Brake Linkages SP, Right, Front, Sand Pro 2020/3020/5020, Page 6

Brake Linkages (SP 5020)

22 23	24	1	2
			3	4	5
17
21

20

21

1920

	18
		17 25 416		6
				7	8	9
		1514				10
			13
			11/12
	RIGHT		26	27		28
							29
	FRONT						30
				31
				32
			Figure 12			23.	Cap screw
1.	Curved washer	12.	Right bearing bracket
2.	Lever bracket	13.	Washer head screw			24.	Spacer
3.	Lock nut	14.	Flat washer			25.	Hourmeter bracket
4.	Lock nut	15.	Cotter pin			26.	Cotter pin
5.	Clevis pin	16.	Traverse rod			27.	Adjustment rod
6.	Lock nut	17.	Cotter Pin			28.	Jam nut
7.	Side flange bearing	18.	Clevis pin			29.	Adjustment clevis
8.	Hex head flange	19.	Strap			30.	Clevis pin
9.	Roll pin	20.	Cap screw			31.	Cotter pin
10.	Brake arm	21.	Flat washer			32.	Brake lever
11.	Left bearing bracket	22.	Lever assembly

Most parking brake linkage parts can be repaired or re- placed without removing any interference. However, the right fender must be removed to work on the parking brake lever.

CAUTION

The muffler and exhaust pipe may be hot. Avoid possible burns; allow engine and exhaust sys- tem to cool before working near the muffler.

1.Remove right fender if necessary (see Right Fender Removal).

IMPORTANT:Make sure to matchmark both parts when removing the clevis from either the brake rod or brake lever or removing the brake lever from the cam shaft on the brake assembly, . Marking both parts will make reassembly and brake adjustment easier.

2.Remove and replace parts as necessary to repair brake linkages (Fig. 12).

3.Reinstall right fender if necessary (see Right Fender Installation).

IMPORTANT:Always check and adjust the brakes anytime brake linkages are disassembled or re- paired (see Brake Adjustment).

Whells, Brakes, and Miscellaneous

Sand Pro 2020/3020/5020 Page 6 – 13 Wheels, Brakes,and Miscellaneous