Lubrication
CAUTION
Before servicing or making adjustments to the machine, stop engine, set parking brake, and re- move key from the ignition switch.
Lubricate grease fittings regularly with No. 2 general purpose lithium base grease. Lubricate front wheel bearing and traction control linkage every 25 hours of operation. Lubricate steering shaft and steering shaft sprocket every 100 hours.
Sand Pro 2020/3020 (Early Models)
The three fittings that must be lubricated are: front wheel bearing (Fig. 1), traction control linkage (Fig. 3) and steering shaft (Fig. 4).
Sand Pro 2020/3020 (Late Models)
The four fittings to lubricated are: front wheel bearing (Fig. 1), traction control linkage (Fig. 3) and steering shaft and steering chain sprocket shaft(Fig. 5).
Sand Pro 5020
The four fittings to lubricate are: front wheel bearing (Fig. 2), traction control linkage (Fig. 3), and both the steering shaft and steering chain sprocket shaft (Fig. 6).
NOTE: On the Sand Pro 5020, gain access to the grease fitting on the traction control linkage (Fig. 3) by removing the right side panel.
1.Wipe grease fitting clean so foreign matter cannot be forced into the bearing or bushing.
2.Pump grease into the bearing or bushing. Wipe up excess grease.
NOTE: Do not lubricate steering chain unless it be- comes stiff from rust. If the chain rusts, it may be lubri- cated lightly with a dry type lubricant.
Figure 1
Figure 2
Figure 3
|
| Figure 4 |
Product Records and Maintenance | Page 2 – 4 | Sand Pro 2020/3020/5020 |
