LOG ASSEMBLY
LOG POSITIONING
This unit is supplied with a set of four ceramic fiber logs. Do not handle these logs with your bare hands! Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fibers.
PROPER INSTALLATION SEQUENCE:
1.Install the rear log (#2) on the rear set of locators. Visually check to verify the log is securely placed on the locators.
2.Install the front log (#1) on the front locators. Visually check to verify the log is securely placed on the locators.
3.Place the cross logs on the locator studs in the log as shown. The flame should not touch the cross logs otherwise suiting will occur.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
#2
#1
FIGURE 8 - Log Set Assembly
WARNING
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly situated in the appliance. Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to the heater.
14
