NOTE: If the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.
4.Aim the Millennium 4 at your TV/VCR Combo and press POWER once. The unit should turn off. If it does not respond, repeat steps 2 and 3, trying each code listed for your brand until you find one that works. If it still does not work, try searching for the code (see Searching For Your Code on page 24).
5.If you’ve found a TV/VCR setup code that works your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the Millennium 4 to access volume control (see Programming TV Control on page 8).
If there is no separate TV code listed, you will need to perform the following steps to access volume control:
a. Press and hold SETUP until the LED blinks twice, then release SETUP.
b. Enter 9 - 9 - 3. The LED will blink twice.
c. Press VCR once. The LED will blink twice.
6.For future reference, write your TV/VCR Combo code in the boxes below.
NOTE: Remember, to use the Millennium 4 to operate your TV/VCR Combo, press VCR first.
Setup Codes for TV/VCR Combos:
American High | 0035 | (for TV use 0051) |
Brocksonic | 0002, 0294, | |
Colt | 0072 |
|
Curtis Mathis | 0035 | (for TV use 0051) |
Daewoo | 0278 |
|
Emerson | 0002, 0294, 0479 | |
Funai | 0000 |
|
GE | 0035 | (for TV use 0051), 0060 (for TV use 0047), |
| 0048 | (for TV use 0093), 0240 |
Hitachi | 0035 | (for TV use 0051), 0000 |
HQ | 0000 |
|
Lloyds | 0000 |
|
MGA | 0240 |
|
Magnavox | 0081 | (for TV use 0054), 0035 (for TV use 0051), 0000 |
continued on next page...
17
