2. Enter 9 - 9 - 3. The VCRkey will blink twice.
3. Press VCRonce. It will blink twice.
4. Now, whenever you press VOL+,VOL–, or
MUTE, volume will be controlled by your VCR.

To change Volume Lock to AUX mode:

NOTE: Performing these steps will allow you to access the
volume control of your auxiliary device in all modes.
1. On the remote control, press AUXonce.
Then press and hold SETUPuntil the
AUXkey blinks tw ice, then release SETUP.
2. Enter 9 - 9 - 3. The AUXkey will blink twice.
3. Press AUXonce. It will blink twice.
4. Now, whenever you pressVOL+, VOL–, or
MUTE, the volume will be controlled by your
auxiliary device.
TROUBLESHOOTING
PROBLEM:
Mode key does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM: Mode key blinks when you press a key, but
home entertainment device does not respond.
SOLUTION: Make sure you are aiming the remote control
at your home entertainment device and that
you are within 15feet of the device you are
trying to control.
PROBLEM: The remote control does not control home
entertainment devices or commands are not
performing properly.
SOLUTION: Try all listed co des for the device brand being
set up. Make sure all devices can be operated
with an infrared remote control.
PROBLEM: TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some
combo units may require both a TV code
and a VCR code for full operation
(see page 9).