CHECKING THE CODES
If you have set up the Cox Universal Remote Control
using the Searching For Your Code procedure on the
previous page, you may need to find out which four-
digit code is operating your equipment. For example, to
find out which code is operating your TV:
1. Turn on your TV.
2. On the remote control, press TVonce .
Then press and hold SETUPuntil the
TVkey blinks tw ice, then release SETUP.
3. Enter 9 - 9 - 0. The TV key will blink twice.
4. To view the code for the first digit, press
1once. Wait 3 seconds and count the number
of times the TV key blinks (for example,
3 blinks =3) and write down the number in
the leftmost TV Code box (see below).
NOTE: If a code digit is “0”, the selected mode key
will not blink.
5. Repeat step 4 three more times for remaining
digits. Use 2for the second digit, 3for the
third digit, and 4for the fourth digit. Write
down the remaining digits in the boxes below.
6. To check for other device codes, repeat steps
1–5, but substitute the appropriate key (that
is, AUX, VCR, or CABLE) for the (Auxiliary,
VCR, or Cable) device you are checking. Write
down the codes in the appropriate boxes
below.
AUX Code
Aux Device ____________________
VCR Code
TV Code
CABLE Code
12
Cox Manual - final - 082103.qxd 8/21/03 1:31 PM Page 12