Universal Electronics DVR/PVR 5 CHECKING THE CODES

5. Press SETUPonce to lo ck in the code.The TV

key will blink twice.

6. To search for the codes ofyour other devices,

repeat steps 1 through 5,but substitute the

appropriate key (e.g.,AUX,DVD, AUD, or CBL)

for the device you are searching for.

CHECKING THE CODES

If you have set up the Atlas DVR/PVR 5-Device Universal

Remote Control using the Searching For Your Code

procedure (on the previous page),you may need to find

out which four-digit code is operating your equipment.

For example,to find out which code is operating your TV:

1. On the remote control,press TVonce; it will

blink once.Then press and hold SETUP until

the TVkey blinks twice, then release SETUP.

2. Enter 9- 9- 0.The TVkey will blink twice.

3. To view the code for the first digit,press 1

once.Wait 3 seconds and count the number

oft imes the TV key blinks (e.g.,3 blinks = 3)

and write down the number in the leftmost

TV Code box on page 11.

NOTE:If a code digit is “0”,the selected mode key

will not blink.

4. Repeat step 3 three more times for the

remaining digits.Use 2for the second digit,

3for the third digit,and 4for the fourth dig it.

Finish writing down the code in the TV Code

boxes on page 11.

5. To check for other device codes,repeat steps

1 through 4,but substitute the appropriate key

(e.g.,AUX, DVD, AUD, or CBL) for the device

you are checking.Write down the codes in the

appropriate boxes on page 11.

Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 25