Atlas DVR/PVR Manual 3/20/03 5:00 PM Page 29
USING THE MASTER POWER KEY
The Atlas DVR/PVR
To Program The Master Power Key:
1.On the remote control, press and hold SETUP until the
2. Enter 9 - 9 - 5. The
3.For the first device you want in the power on sequence, press a device key (e.g., CBL) once .
4.Repeat step 3 up to four more times to add the second,third,fourth,and fifth device,as desired.
5. To save the settings and exit the program, press and hold SETUP until the
To Operate The Master Power Key:
NOTE: If MASTER POWER is not programmed, pressing it will only command the
1.After programming, point the remote control at the devices.
2. Press and hold PWR for at least 2 seconds. You will see the devices power on or off according to the programmed sequence.
To Clear The Master Power Key:
1.Perform steps 1 and 2 in the first section above, To Program The Master Power Key.
2. To clear the settings and exit the program, press and hold SETUP until the
29