Operation
Preparations
This section describes the preparations for operating the
When using the function for playlist editing or content distribution, refer to the Help information for the BZNP- 100LE (supplied) or
1)In the remainder of this manual,
Remote Controller Preparations
The remote controller is supplied with a CR2025 lithium battery and insulating film installed. Removing the insulating film allows the battery to be used.
Caution
The battery may burst if incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.
Main Unit DIP Switch and Remote Controller Settings
To operate the
Then set the remote controller to correspond with the code number setting of the rightmost switch as follows.
When the code number is 1 (the switch is in the “1” position): Hold down the STOP and PAUSE buttons on the remote controller, then press numeric button 1.
When the code number is 2 (the switch is in the “2” position): Hold down the STOP and PAUSE buttons on the remote controller, then press numeric button 2.
Set to the “1” position (ON).
To correspond with the setting of this switch, press numeric button 1 or 2 on
1 
the remote controller while holding down the STOP and PAUSE buttons.
2
Replacing the Battery
On the back of the remote controller, pull out the battery holder. Insert the CR2025 lithium battery with the positive side up, then return the battery holder to its original position.
When operating two
Set the code number to 1 on one of the
Preparations
9
