Universal Electronics PVR 5 manual Programming Tv/Vcr Combo Control, TV/VCR Code, TV Code if used

Atlas DVR-PVR M1055 8/12/04 4:51 PM Page 12

PROGRAMMING TV/VCR COMBO CONTROL

If you own a TV/VCR Combo, perform the following instructions to control this device:

1.Turn on your TV/VCR Combo and insert a video cassette.

2.On the remote control, press AUX once; it will blink once. Then press and hold SETUP until

the AUX key blinks twice, then release SETUP.

3.Use the Setup Codes For TV/VCR Combos (on page 36) to locate the brand name and then enter the first four-digit code for your TV/VCR Combo. If you perform this procedure correctly, the AUX key will blink twice.

NOTE: If the AUX key did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

If you’ve located a TV/VCR setup code that works for your TV/VCR Combo and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see Programming Device Control on page 10).

4.Aim the remote control at your TV/VCR

Combo and press PWR once. The device should turn off. If it does not respond, repeat steps 2 through 3, trying each code listed for your brand until you find one that works.

If it still does not respond, try searching for the code (see Searching For Your Code on the page 13).

5.For future reference, write down each working device code in the boxes below:

TV/VCR Code

TV Code (if used)

12