Universal Electronics URC-3021 manual Re-Assigning Device Keys, Using Channel Scan

CTGAE3P 3021 manual booklet 5/24/04 12:46 PM Page 11

PROGRAMMING A MASTER POWER MACRO (cont’d)

Clearing The Master Power Macro

1.Press and hold SET until the LED (red light) blinks twice, then release SET.

2.Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.

3.Press and hold SET until the LED blinks twice, then release SET. The Master Power Macro is now cleared.

RE-ASSIGNING DEVICE KEYS

The One For All 3 Device Universal Remote Control can be set to control a DVD player and a VCR (or a PVR) or a second DVD player by re-assigning the unused CBL/SAT key as follows:

1.On the remote control, press and hold SET until the LED (red light) blinks twice, then release SET.

2.	Enter 9 - 9 - 2. The LED will blink twice.
3.	Press DVD/VCR once.

4.Press CBL/SAT once. The LED will blink twice. The CBL/SAT key is now ready to be set up to control your VCR (or PVR) or second DVD player. See Programming Device Control on page 8.

NOTE: Only one device can be assigned to an unused device key at a time.

USING CHANNEL SCAN

In the CBL/SAT or TV mode, use the FAV key to start a 3-second scan of all channels. Or, if programmed, use the FAV key to scan only your favorite channels to view a desired channel (see Programming Favorite Channel Scan on next page. )

1.Press CBL/SAT or TV once.

2. Press FAV once.

•If Favorite Channel Scan has been set up,scanning of favorite channels will start with up to 100 channel changes or until stopped by pressing any key.

•If Favorite Channel Scan has not been set up, scanning will start with the current channel, and continue up to

100 channel changes or until stopped by pressing any key.

3.To stop scanning channels at any time, press any key once.

11