6.The ducting must be air tight. Use a minimum of 2 sheet metal screws at every duct joint. Then, seal the duct joints with high quality duct tape.
7.Only use ductwork constructed of materials deemed acceptable by state, municipal and local codes.
8.Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum clearances, unless otherwise specified.
IMPORTANT: If the
IMPORTANT: Hood is 1/8” narrower than widths shown below.
Dimensions
Note: Center of knockout is 8.25” from center of hood & 2.5” from back.
WARNING! Following Are Manufacturer’s Suggestions. Always Observe Local Building Codes.
Hoods installed in custom canopies constructed of combustible materials should be installed with the combustible material structure a minimum of 36” above the cooking surface. Hoods installed in custom canopies constructed of
Item No.