Universal Remote Control MX-500TM

2. Programming The Ten Device Buttons

This will program ONE learned code onto the Device

button, so that when you select that Device, it will send out

the learned signal as it changes to that Device's function

pages.

1. Go to the SETUP mode by pressing both the MAIN and

ENT buttons simultaneously for three seconds.

2. Press the LEARN button next to the LCD screen.

3. Important: Press the PAGE button.

4. Place your original remote control head to head with the

MX-500TM about 2 inches apart on a flat surface.

5. Select any of the ten device buttons you wish to

program on the MX-500TM. Press the button on your

original remote control you wish to program into the

Device button you have chosen on the MX-500TM. Once the

MX-500TM has received the signal, the MX-500TM will flash

“Good” on the LCD screen, indicating it learned the code

correctly. If it flashes “Fail”, repeat from Step 4 until it

learns successfully. (Please enter the code signal within 20

seconds of programming.)

6. Return to Step #5 until you have programmed all of the

Device buttons that you require.

4. Programming the MX-500

to Control Your Components