Universal Remote Control RF20 manual Step, Exit Setup mode by pressing the Main button two times

13

Pre-Programmed Code Method

STEP 9:

Once you have found the right code, save the code number by pressing the SAVE display button that appears on the LCD screen. The LCD screen will blink “SAVED” two times, signaling that the code number has been successfully saved.

STEP 10 :

Exit SETUP mode by pressing the MAIN button two times.

When the LCD screen displays MAIN, you are back in normal operating mode.

NOW, PROGRAM THE REST OF YOUR COMPONENTS BY REPEATING STEPS 1 THROUGH 9. IN MOST SYSTEMS,YOU CAN FINISH BASIC SETUP IN JUST A FEW MINUTES AND PUT ALL YOUR OLD REMOTES AWAY.

IF YOU ARE STILL MISSING COMMANDS TO CONTROL ANY OF YOUR COMPO- NENTS, USE THE LEARNING METHOD ON PAGE 15.

14

Pre-Programmed Code Methoda

BASIC SETUP

SAVE

BUTTON

MAIN

BUTTON

BASIC SETUP