In this example, the VIP-810 is connected to the data network jack already installed and now the network connected telephone can reach into the existing Valcom V-2924A to access all call priority paging. This configuration could be used at a guard shack where network access is available, but not a telephone.
LAN | |
OR | |
WAN | Page Input |
|
| PBX |
Network | |
| V-2924A |
| VIP-800Override Audio |
VIP-810
There are many buildings or areas with existing 70 Volt paging speakers and amplifiers installed. Often times these systems are not operational or do not provide adequate coverage. The VIP-800 is ideally suited for integration with conventional paging products. They can be used to interconnect buildings for paging without the need of additional wire runs. Once connected through the LAN or WAN, the VIP-800 provides line level outputs and auxiliary contact closures that can be interfaced with conventional amplifiers. The illustration shown below depicts how integration is accomplished. From a central location, paging can be accomplished either by specific zone or all call mode.
70 VOLT SYSTEM
Zone 1 Audio
V-1095
Network
LAN
OR
WAN
Note: During initial SETUP, the “Sub-Net Address” and the “Gateway MAC Number (address) of the Sub-Net Power” must be programmed in the software of each unit locally - on the SubNet on which the unit resides.