INSTALLation
Continued
WARNING: Never modify or cover the louvered slots on the front of the firebox.
Mantel Clearances for
Installation
If placing mantel above
NOTICE: Surface temperatures ofadjacentwallsandmantelsbecome hotduringoperation.Walls and mantels above the firebox may become hot to the touch. If installed properly, these temperatures meet the requirement ofthenationalproductstandard. Follow all minimum clearances shown in this manual.
NOTICE:Ifyourinstallationdoes not meet the minimum clearances shown in Figure 11, you must do one of the following:
•raise the mantel to an accept- able height
•remove the mantel
| 10" |
|
| Mantel Shelf | |
Note: |
|
|
|
| |
8" |
|
|
|
| |
All vertical |
|
|
|
| |
measurements | 6" |
|
|
|
|
|
|
|
| ||
are from top of |
|
|
|
| |
2 1/2" |
|
|
|
| |
fireplace |
|
|
|
| |
opening to |
|
|
|
|
|
bottom of |
|
|
|
|
|
mantel shelf. All |
|
|
|
|
|
measurements |
|
|
|
|
|
are in inches. |
|
|
|
|
|
| 13" | 16" | 19" | 21" |
|
|
|
|
|
|
|
Side of
Firebox
OPTIONAL MANTEL Installation
Refer to instructions provided with the mantel for assembly instructions. Refer to the following instructions for system installation. Refer to instructions on page 6 for hood assembly. Blower accessory should be installed prior to mantel if it is being used (see Installing Optional Blower Accessory GA3450TA, page 13).
1.Assemble cabinet mantel as shown in accessory instruction sheet.
2.If blower is installed, install a properly grounded, 120 volt
Figure 12).
3.Place hearth base against wall at installa- tion location. Cut an access hole in hearth base to run gas line to fireplace (see Figure
12). Make sure to locate access hole so cabinet mantel will cover it when installed.
Note: You can secure base to floor using wood screws. Countersink screw heads and putty over.
4.Route flexible gas line through access hole in hearth base.
5.Center cabinet mantel on hearth base (see
Figure 13, page 13). Make sure mantel is flush against wall and centered left to right on base.
6.Use screws provided with mantel accessory to attach mantel assembly to base (see mantel instruction sheet).
7.Attach flexible gas line to fireplace gas regulator. See Connecting to Gas Supply, page 16.
8.Route electrical cord(s) through access holes in either side of fireplace with bushing.
Plug electrical cord(s) into electrical outlet.
Pipe and Gas | Electrical | |
Outlet | ||
Hearth Shutoff Valve | ||
| ||
Base |
|
Figure 11 - Minimum Mantel Clearances | Figure 12 - Placing Hearth Base Against Wall |
| |
for |
|
12 | www.desatech.com |