INSTALLation
Continued
9.Check all gas connections for leaks. See Checking Gas Connections, page 18.
10.Carefully insert fireplace into cabinet mantel (see Figure 13). Be careful not to scratch or damage hearth base or cabinet mantel.
11.Place metal trim on shoulder screws locat- ed on the side and top of the fireplace (see
Assembling Perimeter Trim). Firmly snap trim over shoulder screws. Align fireplace in mantel assembly so the trim overlaps mantel evenly on all three sides.
12.Lower bottom louver door. Use 3" wood screws provided with mantel accessory to attach fireplace to base (see mantel instruction sheet).
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 14).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 14).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other corner.
8.Set trim assembly aside for later installation.
installing blower accessory GA3450TA
Removing Upper Louver Assembly
To install the blower accessory, you must first remove the upper louver assembly.
1.Lift screen off heater.
2.Remove 4 screws from louver assembly (see Figure 15). Save these screws.
3.Pull louver assembly straight out from the cabinet. Be careful not to scratch the paint.
Set louver assembly and screws aside.
Blower Bracket
Mounting Holes
Figure 13 - Installing Fireplace into
Mantel Assembly
Assembling Perimeter Trim
1.Remove packaging from three remaining pieces of trim.
2.Locate two adjusting plates with set screws, and two shims in the hardware packet.
3.Align shim under adjusting plate as shown in Figure 14.
Set Screws | Slot | ||
| |||
|
| Top Trim | |
|
| Mitered Edge | |
Adjusting | Side | ||
Plate | Shim | ||
Trim | |||
| |||
Slot
Figure 14 - Assembling Perimeter Trim
Upper Louver
Black Assembly
Screws
Figure 15 - Removing Upper Louver
Assembly
Removing Valve Cover Shield
1.Open bottom louver assembly by swing- ing the assembly down (see Figure 16, page 14).
2.Using short Phillips screwdriver, remove the screw under the center of the branch support. Rotate valve cover shield clock- wise and slide out.
IMPORTANT: Do not remove shoulder screw on the left side of valve cover shield.
Slide the valve cover shield off of the shoul- der screw (see Figure 16, page 14).
www.desatech.com | 13 |