Vanguard Heating 30 Product Identification, Local Codes, Unpacking, Product Features, Operation

Models: 18 30 24 36" Flame Oak Log

1 26
Download 26 pages 60.64 Kb
Page 3
Image 3
OWNER’S MANUAL

OWNER’S MANUAL

PRODUCT

IDENTIFICATION

Flame-Max®

Golden Oak Logs

One Piece

Log Set

Optional

Remote

Control

Piezo

Ignitor

Optional

Selector FlameBase Assembly

Switch Adjustment

Knob

Control Knob

Figure 1 - Product Identification

LOCAL CODES

UNPACKING

PRODUCT

FEATURES

OPERATION

This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by realistic, dancing yellow flames. This heater is designed for vent-free operation with flue damper closed. It has been tested and ap- proved to ANS Z21.11.2 standard for unvented heaters. State and local codes in some areas prohibit the use of vent-free heaters. This heater may also be operated as a vented decorative product (ANS Z21.60) by opening flue damper (non-thermostat operation only).

SAFETY PILOT

This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS). The ODS/pilot is a required feature for vent- free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.

Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note: Where listed vented decorative logs are required, thermostat operation is not permitted.

PRODUCT CAUTION: Do not remove the metal Data Plates from the grate assembly. The Data Plates contain important product information.

1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by the burner. This could damage heater. Always handle base assembly by grate.

2.Remove all protective packaging ap- plied to logs and heater for shipment.

3.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought heater.

REMOTE CONTROL ACCESSORIES

There are four optional remote controls that can be purchased separately for this log heater:

wall switch

wall thermostat

hand held ON/OFF remote

hand held thermostat remote

See Accessories, page 24.

The wall thermostat or hand-held thermo- stat may not be used where vented decora- tive listing is required.

104309

3

Page 3
Image 3
Vanguard Heating 30, 24, 18 Product Identification, Local Codes, Unpacking, Product Features, Remote Control Accessories