Vanguard Heating 24, 36" Flame Oak Log Installing Logs, Installing Golden Oak One-Piece Log Set

OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS

One Piece Log Set

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

Chassis

Middle

Section at

Bottom of Log

Set

Burner

"U"-shaped Cutout in Chassis

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place one-piece log set on grate to fit as illustrated in Figure 17. Make sure middle section at bottom of log set is seated into “U”-shaped cutout in cen- ter of chassis (see Figure 17). Note: 36” model has more features but fits on the chassis the same. Log will fit securely on chassis. IMPORTANT: Make sure log does not cover any burner ports.

2.Place lava rock around base of heater.

Figure 17 - Installing Golden Oak One-Piece Log Set

Burner
Ports	One Piece Log Set

Figure 18 - Installing Golden Oak One-Piece Log set (Top View)

104309 13