OWNER’S MANUAL
INSTALLATION
Continued
Mounting Heater to Optional Hearth Base
1. | Lay heater on its back on a table with |
| the bottom of heater overhanging the |
| edge of the table. |
2. | Remove 2 shipping screws in bottom |
| of heater. Discard shipping screws. |
3. | Line up mounting holes on top of hearth |
| base with holes in bottom of heater (see |
| Figure 16). |
4. | Using a Phillips screwdriver, secure |
| hearth base to heater with four sheet |
| metal screws (see Figure 16). |
5. | Stand heater up on base. |
6. | Place hearth insert in hearth base as |
| shown in Figure 17. |
7. | Assemble brass trim (see steps 1 |
| through 7 under Assembling and At- |
| taching Brass Trim, page 4). |
8. | Slide base trim on heater base. Attach |
Securing Hearth Base to Floor
1.Position hearth base in desired location. Mark holes for drilling (See Figure 16). Remove hearth base.
2.For carpeted floor, make a small cut with a sharp knife at marked locations before drilling.
If securing to a wood floor, drill a 3/4" deep hole using a 1/8" diameter drill bit. Do not use anchors in wood floors. If securing to a concrete floor, drill a 1 3/8" deep hole using a 1/4" diameter concrete drill bit. Completely insert anchors into each hole.
3.Mount heater to hearth base following steps under Mounting Heater to Op- tional Hearth Base. After mounting heater, position heater and hearth base over drilled holes. With slotted screw- driver, secure hearth base to floor with four wood screws.
C. MOUNTING HEATER TO OPTIONAL MANTEL.
See Instructions Included With Mantel Kit.
IMPORTANT: Only use the optional man- tels specified in this manual. See Accesso- ries, page 23 for proper mantel kits. This heater is only approved for use with models GMF800/GMU801 series, GM900F/ GM901U series, GM902F/GM903U series, GM700F/GM701U, and GM702F/ GM703U series mantel kits. Using any other mantel will void the CSA approval for this heater. Only use models GMF800/GMU801 series, GM900F/GM901U series, GM902F/ GM903U series, GM700F/GM701U, and GM702F/GM703U series mantels with this heater. Do not use these mantels with any other product.
brass trim to base with two brass screws |
included as shown in Figure 17. |
Shipping Screw | Bottom of Heater |
Base
| Mounting |
| Holes |
Holes for Securing | Sheet Metal |
Heater to Floor | Screw |
Figure 16 - Attaching Heater to Hearth Base
Hearth
Insert
Screw
Brass Base
Trim
Figure 17 - Placing Hearth Insert on Heater
Base and Attaching Brass Base Trim
Continued
107098 | 11 | For more information, visit www.desatech.com |
