Vanguard Heating VMH3000TPA Continued, Attaching Brass Front Trim to Front Panel, Assembly

®

PROPANE/LP GAS RESIDENTIAL HEATERS

ASSEMBLY

Continued

		Deflector
Log		Heater Cabinet
		Hood
Front Panel	Sheet Metal	Log
		Retaining
	Screw
		Brackets
Truss-
Head
Screw		Burner Shield
	Nut

Screw

Screen

Brass Front Trim

Screw

5.Slide other end of adjusting plate/shim in slot on mitered edge of side brass trim (see Figure 5).

6.While firmly holding edges of brass trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other side.

8.Place the assembled trim on front of heater cabinet. Attach on top and sides with four brass screws included in hard- ware package (see Figure 6).

9.Reattach front panel to heater if you are going to mount the heater to the base. Do not reattach front panel at this time if you are going to mount heater to wall.

Adjusting

PlateTop Brass

Trim

Side Brass

Trim Set

Screws

Figure 3 - Assembling Heater

WARNING: Always have burner shield and screen in place before operating heater. This pre- vents excessive temperatures on heater surfaces.

Failure to position the parts in accordance with these diagrams or failure to use only parts spe- cifically approved with this heater

Brass Front Trim

Truss-Head

Screw

Front Panel

Nut

Shim Slot

Slot Mitered Edge

Figure 5 - Assembling Brass Trim

Screws

Assembled

Brass Trim

may result in property damage or personal injury.

Figure 4 - Attaching Brass Front Trim to Front Panel

Attaching Brass Front Trim to Front Panel

1.Locate brass front trim in brass trim package.

2.Slide the head of two truss-head screws from hardware packet into each end of brass front trim (see Figure 4).

3.Line up screws with holes in front panel (see Figure 3). Insert screws in holes. Attach nuts from inside of front panel. Tighten with wrench.

Assembling and Attaching Brass Trim

1.Remove packaging from three remain- ing pieces of brass trim.

2.Locate four brass screws, two adjust- ing plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 5.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 5).

Figure 6 - Attaching Brass Trim to Heater

For more information, visit www.desatech.com 4 107098