®
INFRARED NATURAL GAS HEATER
INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater car- ton. Remove mounting bracket from heater carton.
Mounting
Bracket
Figure 5 - Mounting Bracket Location
Removing Front Panel Of Heater
1.Remove two screws near bottom cor- ners of front panel.
2.Lift straight up on grill guard until it stops. Grill guard will slide up about 1/4".
3.Pull bottom of front panel forward, then down.
Figure 6 - Removing Front Panel Of Heater
Methods For Attaching Mounting Bracket To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways.
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to wall stud: This method pro- vides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to wall anchor: This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mounting bracket is level.
WARNING: Maintain minimum clearances shown in Figure 7. If you can, provide greater clear- ances from floor and joining wall.
2.Mark screw locations on wall (see Fig- ure 7).
Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3.Remove tape and mounting bracket from wall.
13" | 16" |
Min. |
|
AdjoiningWall |
| Only Insert Mounting | 18 3/4" | ||
|
| Screws Through Last | |||
|
| Min. | |||
|
| Hole On Each End |
| ||
|
|
|
| ||
|
| Floor |
|
| |
|
| Model VN3000TB |
|
| |
| 9 1/4" | 16" |
|
| |
| Min. |
|
|
| |
AdjoiningWall | Only Insert Mounting | 18 3/4" | |||
Screws Through Last | |||||
| Min. | ||||
|
| Hole On Each End |
| ||
|
|
|
| ||
Floor
Model VN1800TB
Figure 7 - Mounting Bracket Clearances
8 | 104820 |
