Vector 90519434, SLH100V Operating Instructions, Care and Maintenance, Using the Spotlight

2.Insert the DC pin in the charging port on the side of the light.

3.Charging time using this method is approximately 5 to 6 hours.

4.When charging is complete, remove the power cord.

Note: When using a vehicle’s 12 volt DC accessory outlet as a charging source, be aware that some vehicles require the ignition be turned on to power the accessory outlet.

OPERATING INSTRUCTIONS

Using the Spotlight

The HID Spotlight is operated by the switch located on the handle of the unit. The Charging/ON LED indicator will light blue when the unit is turned ON.

Using the Adjustable Work Stand

Set the hands-free adjustable work stand to the desired position; the stand will click into position.

CARE AND MAINTENANCE

CAUTION

To reduce the risk of burns and avoid damage to the unit, make sure all power switches are in the OFF position, all adapters are unplugged and the unit has been allowed to cool down before replacing the battery and performing any care and maintenance on the exterior of the light.

All batteries lose charge with time. AC recharge is recommended after each use or every two months when not in frequent use.

If the unit gets dirty, gently clean the outer surfaces of the Spotlight with a soft cloth moistened with a mild solution of water and detergent. Periodically inspect the condition of recharge adapters, connectors, and wires. Replace any components that may have become worn or broken.

Replacement Parts

The sealed lead acid battery is the only user-replaceable part in this light and it is available through Vector Products, Inc. These can also be purchased from popular automotive parts suppliers nationwide. Contact Vector Products, Inc.’s Technical Support Department for replacement parts (including replacement adapters and cords) and any additional information that you may need. They may be reached toll free at (800) 544-6986.

6