Battery Replacement
1.Remove screws and rotate the back cover counterclockwise.
2.Pull out and remove the battery.
3.Disconnect the terminals and replace the battery with the same type and size listed in the Specifications section in the back of this manual.
4.Replace the battery compartment cover and screws.
5.Turn the spotlight’s ON/OFF switch to the ON position to ensure proper operation of spotlight.
Safe Battery Disposal
Contains a
TROUBLESHOOTING | Possible solution | |
Problem | Possible Cause | |
Switch is ON, | Internal battery power is Low. | Turn switch OFF and using the battery status |
Power LED is lit |
| indicator, check for Low battery and if Low |
AND Spotlight |
| recharge the spotlight with either the AC or DC |
will not light. |
| charging adapter provided. |
| Power was interrupted to | A hot bulb may take up to 10 minutes to turn on |
| the spotlight while the | following a power interruption. Turn switch OFF |
| bulb was hot. | and wait 10 minutes for bulb to cool down before |
|
| reusing the light |
|
|
|
| AC or DC recharge adapter | Turn switch OFF, unplug the recharge adapter |
| is plugged into the light | and then turn the switch back ON. |
|
|
|
| Spotlight needs to be | Turn switch OFF wait 2s and turn the switch back |
| manually reset. | ON. If problem persists return the spotlight to an |
|
| authorized service center for repair. |
|
|
|
| Spotlight is damaged. | Turn switch OFF and return the spotlight to an |
|
| authorized service center for repair. |
|
|
|
Unit will not | Vehicle ignition is not | On some vehicles the ignition must be in the |
recharge. | in Accessory position. | accessory position to supply power to the 12V |
|
| receptacles. Turn the vehicle ignition to the |
|
| accessory position and try charging the |
|
| spotlight again. |
|
|
|
| Poor DC plug connection | Check DC adapter plug is well connected and |
|
| try recharging the light. |
| DC recharge adapter | See an authorized service center to get a |
| is damaged | replacement DC recharge adapter. |
|
|
|
| Poor 120V AC recharge | Check that the adapter is well connected to the |
| adapter connection | 120V AC outlet and to the light and try |
|
| recharging the light. |
|
|
|
| No power at the 120V | Try another 120V AC powered device in the |
| AC outlet | outlet to see if it has power. If it does not the 120V |
|
| AC circuit breaker may need to be reset. Contact |
|
| a certified electrician if you are not comfortable |
|
| resetting the 120V AC branch circuit. |
|
|
|
7
