OPERATION AS A 12 VOLT DC PORTABLE POWER SUPPLY
The 12 volt DC outlet provides 15 amps maximum current for 12 volt DC operat- ed appliances.
1.Lift up the cover of the unit’s 12 volt DC accessory outlet (See Figure 2).
2.Insert the 12 volt DC plug from the appliance into the outlet on the unit.
3.Switch on the appliance, and operate as usual.
CAUTION: DO NOT USE THIS UNIT TO OPERATE APPLIANCES THAT DRAW MORE THAN 20 AMPS DC.
Table I - Using the unit as a 12 volt DC Power Supply
Appliance | Estimated Power Usage | Operating Time |
| (Watts) | (hours) |
Cell phone | 1 | |
Fluorescent light | 4 | 40 |
Radio, fan, depth finder | 9 | 24 |
Camcorder, VCR, spotlight | 15 | 14 |
Power tools, bilge pump | 24 | 10 |
Car vacuum | 80 | 2 |
NOTE: All times are approximate and based upon a fully charged unit.
EMERGENCY AREA LIGHT
The Area Light is controlled by an ON/OFF switch. Make sure the area light is turned OFF when the unit is being recharged or stored.
JUMP ’N CHARGE SPECIFICATIONS
Model No | . . . . . . . . . . . . . . . . . . . . . VEC012B |
Maximum Output Current (instant) . | . . . . . . . . . . . . . . . . . . . . .450 Amps |
Weight | . . . . Approximately 17.8 lbs. (8.0 Kg) |
Battery Type | . . . . . . . .12 Volt, 19AH/20HR Sealed |
| Rechargeable |
Jumper Cables | . . . . . . . .Heavy Duty, Welding Cable |
Cables Clamps | . . . . . . . . 450 Amp, Copper Clamps |
Area Light | . . . . . . . . . . . . . . . . Ultra Bright LEDs |
Vehicle Test Voltage | . . . . . . . . . . . . . .Greater than 3 Volts |
Accessory Outlet | |
DC Charging Adapter | . . . . . . . . . . . . . . . . . . . .12 Volt DC |
Reverse Polarity Detection | . . . . . . . . . . . . . . . . . . .2 Volts (min) |
12 Volt Outlet Output | . . . . . . . . . . . . . . . . . . . . . .15 Amp |
Charger Output | . . . . . . .12 Volt DC 6 Amp Maximum |
Alternator Check | . . . . . . . . . . . . . . . . .13.5 - 16.0 Volt |
14
