Vector VEC016 owner manual On/Off

1.INTRODUCTION

Congratulations on selecting the Vector® Model VEC016 Compact Jump Starter and DC Power System. It can jumpstart most vehicles or boats with a standard 12 volt DC electrical system: boat, small truck, car, airplane, RV, personal watercraft, snowmobile, tractor, etc. Note that this jump starter is extra safe compared to others because it has a Safety Power Switch and a self- contained Audible Polarity alarm that sounds when the cable clamps are connected to incorrect polarity.

This advanced design is perfect for work during emergencies and it can also enhance your fun by powering DC appliances to 15 amperes on the road, at the beach and at camp. Be sure to read and understand all WARNINGS and CAUTIONS before using this product. Please read this guide carefully before use to ensure optimum performance and avoid damage to the sys- tem or items that you are using it with.

The built-in work/area light is invaluable when it becomes necessary to locate battery terminals while preparing to jump-start a dead battery in the dark.

It is also ideal for use with Vector(tm) 12 volt DC cordless, portable, rechargeable appliances with ratings up to 15 amperes. For information about Vector appliances, contact Vector Manufacturing at 866-584-5504 (toll free) for the location of the nearest retailer.

The unit has an easy-to-read, series of LEDs (Light Emitting Diodes) arranged as a Charge Status Display that shows the level of charge in the battery (from Low to Full). The Charge Status Display activates whenever the Charge Status Pushbutton is pressed or automatically during AC recharge operations. One 12-volt DC cigarette lighter-type (accessory) socket is provided for use with appliances that can operate from a cigarette lighter type accessory socket. The DC accessory socket allows for DC recharge from a vehicle or other 12 volt source. Note that the exposed electrical socket and recharge port has a cover that help keep out dirt, dist and moisture. All covers must be open for socket or port use and closed after use.

FIGURE 1	POWER SAFETY SWITCH
DC RECHARGE/	RECHARGE PORT
ACCESSORY SOCKET
WORKLIGHT	BATTERY
	STATUS DISPLAY
WORKLIGHT	BATTERY STATUS
ON/OFF
SWITCH	PUSHBUTTON
	POS CABLE AND
NEG CABLE AND	CLAMP (RED)
CLAMP (BLACK)

The Safety Power Switch is located on the upper right side of the unit. When the Safety Switch it is in the OFF position, The cable clamps are not powered and the audible polarity alarm is ready to sound if the clamps are connected to incorrect polarity.

Below the Safety Power Switch is the AC Recharge port. It is covered by a rubber cap that keeps dust, dirt, and moisture out of the socket. The AC Recharge Adapter’s barrel connector plugs into this port during recharge.

5