Vector VEC021STC owner manual Using the Power on Board AS a JUMP-START System

Models: VEC021STC

1 16
Download 16 pages 36.41 Kb
Page 7
Image 7

2.USING THE POWER ON BOARD® AS A JUMP-START SYSTEM

WARNING:

1.Before using this system to jump-start any vehicle or boat, read and understand all instructions, safety tips, warnings, cautions and first aid information provided in this manual and on the product labeling. Additional important information may also be provided by the vehicle’s battery system manufacturer.

2.Be aware of first aid procedures before attempting jump-start procedure.

3.Always wear protective eyewear when working with a lead acid-type battery.

4.Do not smoke or use inflammable items (matches, cigarette lighters, etc.) while working on a vehicle’s battery system.

5.When using this jump-starter in proximity to the vehicle’s battery and engine, stand the unit on a flat, stable surface, and be sure to keep all cords and cables well away from any moving parts.

6.Check unit periodically for wear and tear. Replace worn or defective parts immediately contact Vector Customer Service Department toll-free:

(866) 584-5504 or through our Internet address: www.vectormfg.com.

7.Do not attempt to jump-start a frozen battery.

8.NEVER submerge this unit in water.

9.Do not wear vinyl clothing when jump-starting a vehicle, friction can cause dangerous static electricity sparks. Remove all jewelry or metal objects-they can cause short circuits or react with battery acid to cause severe burns. Remove or secure any loose clothing, and restrain long hair, before attempting jump-start procedure.

10.Lead-acid batteries generate hydrogen gas during normal operation. More gas is generated when the battery is charging. Hydrogen gas is explosive, poisonous to breathe and highly flammable.

Recommendations for optimum performance of the POWER ON BOARD Jump-starter:

CAUTION:

1.To avoid possible damage that may shorten the unit’s working life, protect this unit from direct sunlight, direct heat and moisture.

2.This system is to be used ONLY on vehicles, boats, garden tractors and gasoline powered generators with 12 Volt DC battery systems.

3.This system is NOT designed to be installed as a replacement for a vehicle battery.

4.Vehicles that have on-board computerized systems may be damaged if vehicle battery is jump-started. Before jump-starting this type of vehicle, read the vehicle owner’s manual to confirm that external-starting assistance is advised.

5.Excessive engine cranking can damage the vehicle’s starter motor. If the engine fails to start after the recommended number of attempts, discontinue jump-start procedure and look for other problems that may need to be corrected.

6.This POWER ON BOARD® jump-starter is equipped with an internal, automatic safety switch. This switch only activates when connections to the battery are correctly made;positive (+) to positive (+) and negative (-) to negative (-). An incorrect connection will sound an audible alarm indicating an incorrect connection. Should this alarm sound, remove the clamps and reconnect insuring proper polarity. Once the connections are properly made, the internal switch turns on and you are ready to jump-start the vehicle. This automatic internal safety switch is fully automatic and requires no action by the user.

7

Page 7
Image 7
Vector VEC021STC owner manual Using the Power on Board AS a JUMP-START System