Velodyne Acoustics DPS-12, DPS-10 Rear Panel Connections, Low-Pass Crossover, PHASE Switch

Figure 2. DPS Rear Panel Connections

Rear Panel Connections

Figure 2 shows the connections on the rear panel of the DPS. Following are brief descriptions of the connections described in Figure 2. More detail on these connections can be found on the next page.

(1) LOW-PASS CROSSOVER

Use this knob to select the high-frequency range at which you wish to cut off the signal to the subwoofer. When the knob is turned all the way to the left, the Subwoofer Direct feature is invoked and the subwoofer plays all frequencies up to 200 Hz.

(2) PHASE Switch

Allows you to optimize the subwoofer performance for the location and your listening position. Select the switch position at which you hear more bass.

(A) LINE INPUT/LFE Input
Connect these jacks to the LINE OUT preamp output, LFE output or subwoofer output jack(s)
of your receiver/processor. If using the LFE output from your receiver or processor, plug the
single cable into the “L” — LFE input.
.w w w . v e l o d y n e . c o m	DPS User’s Manual	6