Velodyne Acoustics IA-400 manual IA - IWS1 In - Wall Subwoofer

w w w . c h r y s a l i s a c o u s t i c s . c o m

IA - IWS1 (In - Wall Subwoofer)

-Two high excursion 6.5” active drivers, two 12.5” x 3” oval passive radiators with ribbed rubber surround

-High-excursion rubber surrounds on both active and passive drivers

-2” 4 layer copper voice coils

-Frequency Response: 30 - 120Hz (+/- 3 dB)

-4 ohm impedance

NOTE: The IA-IWS1 must be driven with the IA-400 subwoofer amplifier. Use of any other power source voids the warranty.

S E T U P C H E C K L I S T

Be sure to do the following to ensure the best performance from your subwoofer:

❑If possible, optimize the placement of the subwoofer(s) in the listening area. See page 9 of the User’s Manual.

❑Install and wire the subwoofer per the instructions on pages 3 - 9.

❑Select the proper volume level. See page 4.

❑Be sure the low pass crossover is set correctly. See pages 8 - 9.

❑Be sure to equalize the subwoofer using the microphone and Auto-EQ feature. See page 10.

❑Be sure to set the phase control on the remote. See page 10.

❑Select the correct preset for the source material. See page 12.

Your new Chrysalis subwoofer system provides for a number of installation options. Read all the installation information below in order to determine which installation option is best for your system. Remember to perform all installation procedures with system power turned off.

NOTE: For proper set-up and installation of the IA-IWS1 (In-Wall Subwoofer), please refer to IA-IWS1 Quick Install Guide.

InstallAdvantage IA-400 Amp manual 2