
1.4.How to Discharge the Capacitor on Flash PCB
CAUTION:
1.Be sure to discharge the capacitor on FLASH PCB.
2.Be careful of the high voltage circuit on FLASH PCB when servicing.
[Discharging Procedure]
1.Refer to the disassemble procedure and Remove the necessary parts/unit.
2.Put the insulation tube onto the lead part of Resistor (ERG5SJ102:1kΩ /5W). (an equivalent type of resistor may be used.)
3.Put the resistor between both terminals of capacitor on FLASH PCB for approx. 5 seconds.
4.After discharging confirm that the capacitor voltage is lower than 10V using a voltmeter.
Fig. F1
4