8.3.9.Removal of the Battery Case
Fig. D11
NOTE: (When Assembling)
Be sure to confirm the following points when assembling.
•The Screw is tightened enough.
•Assembling conditions are fine. (No distortion, no illegal- space.)
•No dust and/or dirt on every Lens surfaces.
•LCD image is fine. (No dust and dirt on it, and no gradient images.)
8.4.Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1.To minimize the possibility of the CCD being dirt, perform disassemble and/or assemble under the condition of the CCD is being mounted.
Disassembling procedures for the CCD unit, refer to item 8.6.
2.Take care that the dust and dirt are not entered into the lens.
In case of the dust is putted on the lens, blow off them by airbrush.
3.Do not touch the surface of lens.
4.Use lens cleaning KIT (BK)(VFK1900BK).
5.Apply the grease to the point where is shown to" Grease apply" in the figure.
8.4.1.Zoom Motor Unit and Master
Frange Unit
1.Unsolder (16 points).
2.Remove the libs (4 points).
3.Unscrew the 6 screws (A).
4.Remove the zoom motor unit.
5.Remove the master flange unit.
28
