SC - 600 IW, SC - 600 IF/IC SUBWOOFERS
SC-600 IW (In-Wall):
-Two high excursion 6.5” active drivers, two 12.5” x 3” oval passive radiators with ribbed rubber surround
-
-2” 4 layer copper voice coils
-Frequency Response:
-4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
-12” (9.7” piston diameter) subwoofer
-2.5” 4 layer copper voice coils
-Oversized spider for linearity at high excursion
-
-Frequency Response:
-4 ohm impedance
Note: The
S etup Checklist
Be sure to do the following to ensure the best performance from your subwoofer:
❑If possible, optimize the placement of the subwoofer(s) in the listening area. See page 10 of the User’s Manual.
❑Install and wire the subwoofer per the instructions on pages 3 - 8.
❑Set the amp to the proper subwoofer model per the instructions on page 11.
❑Select the proper volume level. See page 4.
❑Select the proper
❑Equalize the subwoofer using the microphone and
❑Adjust the phase control on the remote to the correct setting. See page 12.
❑Select the correct preset for the source material. See page 13 - 14.
Your new Velodyne subwoofer system provides for a number of installation options. Read all the installation information below in order to determine which installation option is best for your system. Remember to perform all installation procedures with system power turned off.
Note: For proper setup and installation of the
.w w w . v e l o d y n e . c o m |
2 |