Velodyne Acoustics SC-602 I n s ta l l a t i o n, Power Switch, Power LED, Mic Input, Remote Eye

I n s ta l l a t i o n

FRONT PANEL CONTROLS AND DISPLAYS

FRONT PANEL CONTROLS AND DISPLAYS 602

Figure 1: Front Panel Connections of the SC-602 amplifier.

Following are brief descriptions of the controls described in Figure 1. More detail on these controls can be found in the next section.

(1) Power Switch

This button forces your SC-602 amplifier into standby mode. The power LED turns amber, the numeric LED shuts off, and the amplifier puts out no power. The unit will remain in this mode until the POWER button is pressed again. To fully deactivate (i.e. power down) the unit, use the main power switch on the back panel.

(2) Power LED

This LED illuminates when the power is on. Blue indicates normal operation. The LED turns amber when the unit is in standby mode or the remote has been used to deactivate the unit, and dims when the unit is in night mode.

(3) Mic Input

Connect the supplied microphone for the Auto-EQ feature to this mini-jack input.

(4) Remote Eye

This is the eye that receives infrared commands from the supplied remote control.

(5) Crossover

Use these UP and DOWN buttons to select the frequency below which all signals will be routed to the subwoofer (for example, 80 Hz), rather than to the main speakers. The frequency is briefly indicated on the LED display, then the display reverts to showing the subwoofer’s volume level. The slope is fixed at 24 dB/octave. To deactivate the crossover, press BOTH the UP and DOWN crossover buttons at the same time - two dashes on the display indicate the crossover is deactivated and the woofer plays all frequencies presented to it. Please see page 8 for a more detailed discussion on crossovers.

.w w w . v e l o d y n e . c o m SC-602 Amplifier User’s Manual

3