Sherwood EF-3 BAYI How To Start And Operate Your Pellet Appliance, Turning Your Pellet Stove Off

HOW TO START AND OPERATE YOUR PELLET APPLIANCE

1.Check and fill hopper with pellets.

2.Switch on power by pushing the start up switch once only.

3.Turn the Dial A Fire knob to the 12 o’clock position. (Lower grade pellets may need a higher setting on the feed rate). NOTE: unit will take longer to light if the hopper has been completely emptied.

CONVECTION

BLOWER SPEED

CONTROL

4.Wait until the fire is established, then turn knob “B” to the desired heat output. (The stove may not be able to burn in the BLUE ZONE if poor quality wood pellets are being used.) Adjust the Slider Damper to the appropriate setting.

5.If the stove should shut off after 15 minutes and there is still a fire in the firebox – press the start up switch once more. If the fire went out, return to step number 2 and re-light the stove.

AUGER LIGHT

START-UP

SWITCH

DIAL-A-FIRE

HEAT

OUTPUT

KNOB

6Adjusting the blower speed control knob will vary the rate of airflow into the room by varying the speed of the convection blower. *Note: The convection

blower may cycle to high automatically depending on the setting of the controls. This is a normal safety feature of the unit.

TURNING YOUR PELLET STOVE OFF

To turn your stove off, simply turn the HEAT OUTPUT knob (knob “B”) counter-clockwise until the knob clicks to the “off” position. This will stop the feed of pellets. The blowers will continue to run and cool the stove. When cool enough the stove will shut down.

SPECIAL NOTES:

-The flashing green light corresponds to the auger feed rate.

The scale on the Dial A Fire knob represents a range, not exact at times. Wood pellets of differing quality may effect the performance of the stove. If the stove has trouble operating at the end of its range, turn the heat output knob back slightly.

6