SLIDER/DAMPER INSTALLATION /OPERATION INSTRUCTIONS
This is used to regulate the airflow through the pellet stove.
INSTALLATION
1.Remove the slider rod (short rod with knob and nuts) and the two nuts from their package and open the left side panel.
2.Remove the knob and outer nut from the knob. Push the rod through the hole in the slider. Place the lock nut on the rod and tighten, leaving a 1/32’ gap between the slider and one of the nuts.
3.Make sure the slider moves freely. Close the side panel and tighten screws after placing the rod through the panel. Screw the knob onto the slider.
OPERATION
-
-
-
ON LOW
Push all the
way in
On the low heat output settings, push the slider all the way in.
On the high heat output pull the slider out or until a good fire is achieved. A good fire is in between a fire with lazy flames (and black tipped flames) and a forced fire (very quick, shorter flames). A good fire is the most efficient and will have a bright and active flame.
Hot magnetic reading 0.10 – 0.11
ON HIGH
Pull out until
an efficient
flame is
achieved
THE TUBE SCRAPER ROD: Put the stainless steel rod through the hole in the heat exchanger, thread the rod into the scraper plate.
7
