POWER
This button forces your SPL-R unit into standby mode. The woofer will not play and the LED will turn off. The unit will remain in this mode until the POWER button is pressed again. To fully deactivate (i.e. power down) the unit, turn off the power switch on the back panel.
MUTE
This button mutes the subwoofer. The light on the subwoofer will blink slowly if the unit is muted. To unmute the subwoofer, press the MUTE button again.
EQ
This button automatically EQs the subwoofer using a 6-band internal graphic equalizer. To use this feature, first plug in the supplied microphone into the Mic In jack on the back panel of the subwoofer and place the mic in your preferred listening position. Then, by pressing EQ on the remote, the subwoofer emits 12 “sweep tones” that cover the frequencies between 20 and 150 Hz. After the sweeps are complete, the unit saves its EQ settings and returns to normal operation. In order to avoid accidentally activating the EQ feature, you will need to hold down the EQ button for 1 to 2 seconds before the EQ sweep tones activate.
NOTE: Each time the EQ feature is utilized, the EQ settings for the SPL-R are reset. If the microphone is not plugged in, the SPL-R will emit a single sweep tone then cease the EQ operation. In this case, the previous EQ settings will be preserved.
PHASE | |
These buttons allow you to optimize the subwoofer performance |
for the location and your listening position. Select the switch |
position at which you hear the most bass. The light will blink |
according to the following schedule: |
0 degrees | 1 blink |
90 degrees | 2 blinks |
180 degrees | 3 blinks |
270 degrees | 4 blinks |
LIGHT
If you wish, you can deactivate the blue front panel light on your SPL-R unit. To do this, press the LIGHT button on your remote. The light will turn off. To reactivate the light, press the LIGHT button again.
10
