Line-level connection
Figure 1 shows connection to a
When installed in this fashion, your satellite speakers will be crossed over at 85hz, which removes the lower bass from your amplifier and speakers thus, enabling them to do a better job reproducing high frequencies. By utilizing this method, you will have a
Figure 1: Installation using
VOLUME PHASE FREQUENCY
A word about subwoofer outputs
The Velodyne subwoofer is designed to operate using the full range audio signal for input when using the
Note
If not using an external crossover, you should use the
Subwoofer out from A/V
Processor
From the low pass output of your signal processor Install into right or left RCA line in connector in the back of the subwoofer or use a "Y" connector adapter into both right and left RCA line in connectors in the back of the subwoofer.
Speaker-level connection
Figure 2 shows an easy way to connect your
CAUTION!
WARNING:
AVIS:
MAIN OUTPUTS
RIGHT LEFT
AMPLIFIER
MAIN | INPUTS | MAIN OUTPUTS |
RIGHT | LEFT | RIGHT LEFT |
When connected in this fashion, your satellite speakers will be crossed over at 85hz, which removes the lower bass from your speakers thus, enabling them to do a better job reproducing high frequencies.
You may also connect your satellites directly to your receiver or amplifier along with the subwoofer if you wish to bypass the internal
Caution!
TO SATELLITE SPEAKERS
To avoid damage to your main amplifier, be sure to maintain correct polarity when making all connections. Red (positive) to red, and black (negative) to black. Be sure that all connections are tight, and that there are no loose strands or frayed wires.
continued. . .
5 | ☞ | 6 | ☞ |
|
|
|
|