Sharp PG-D4010X Regarding the Lamp Continued, Removing and Installing the Lamp Unit, Info

Regarding the Lamp (Continued)

Removing and Installing the Lamp Unit

Warning!

•Do not remove the lamp unit from the projector right after use. The lamp and parts around the lamp will be very hot and may cause burns or injury.

Optional	Lamp unit
accessory	AN-D400LP

Info

•Do not touch the glass surface of the lamp unit or the inside of the projector.

•To avoid injury to yourself and damage to the lamp, make sure you carefully follow the steps below.

•Do not loosen other screws except for the lamp unit cover and lamp unit.

1Press STANDBY/ON on the projector or STANDBY on the remote control to put the projector into standby mode.

2 Disconnect the power cord.

•Unplug the power cord from the AC socket.

•Leave the lamp until it has fully cooled down (about 1 hour).

3 Remove the lamp unit cover.

•Close the lens shutter. Loosen the user service screw (1) that secures the lamp

unit cover. Remove the lamp unit cover (2).

STANDBY/ON button

AC socket

2

1

User service screw (for lamp unit cover)

56