Sharp PG-D4010X Adjusting the Projector Function “PRJ - ADJ” Menu Continued, Speaker Setting

Adjusting the Projector Function (“PRJ - ADJ” Menu) (Continued)

Menu operation n Page 38

6 Audio Output Type Setting

This function determines whether the audio level output from the AUDIO output (MONITOR output) terminal is fixed or variable by linking with VOLUME.

Selectable	Description
items
FAO	Audio output that does not vary in
(Fixed Audio	strength with the volume level of the
Output)	source projector.
VAO	Audio output that varies in strength
(Variable	with the volume level of the source
Audio	projector.
Output)

Info

•When “Audio Out” has been set to “VAO”, fi rst make sure to lower the volume of the projector before turning the power on or off and when switching the input.

7 Speaker Setting

Selectable	Description
items
On	The audio signal is output from the
	internal speaker.
Off	The audio signal is not output from the
	internal speaker.

9 Selecting the Transmission

Speed (RS-232C)

Make sure that both the projector and computer are set for the same baud rate.

Selectable	Description
items
9600bps	Transmission speed is slow.
38400bps
115200bps	Transmission speed is rapid.

0 Fan Mode Setting

This function changes the fan rotation speed.

Selectable	Description
items
Normal	Suitable for normal environments.
High	Select this when using the projector at
	altitudes of approximately 1,500 meters
	(4,900 feet) or more.

When “Fan Mode” is set to “High”, the fan rotation speeds up, and the fan noise becomes louder.

System Lock Function

This function prevents unauthorized use of the projector. Once this function is activated, users must enter the correct keycode each time the projector is turned on. We suggest you record the keycode in a safe place where only authorized users have access.

8 Audio Input

This function allows you to select an appropriate combination of audio input terminals for each input mode.

Selectable	Description
items
Audio 1	The AUDIO 1 input terminal is used as
	an audio input terminal.
Audio 2	The AUDIO 2 input terminal is used as
	an audio input terminal.

Info

•If you lose or forget your keycode, contact your nearest Sharp Authorized Projector Dealer or Service Center (see page 61). Even if the product warranty is valid, the keycode reset will incur a charge.

a Setting/Changing the keycode

1 Select “System Lock”, then press

ENTER or Q.

2 Select “Next”, then press ENTER.

•The screen for entering the keycode appears.

46