Replacement of gear and coupling
1Place the rubber coupling into the locking ring so the rubber feet from the coupling hang below the ring. When placing the coupling and ring on the center shaft of the fan the rubber feet should line up with the notch marks on the fan.
2Snap the ring and coupling into place.
3With the gear laying on its side place it between the motor housing arms that suspend it above the fan.
4While placing the palms of your hands against the motor housing arms, apply slight pressure, and pivot the gear to the operating (upright) position. Check that the locking knob (flange) is properly seated. The locking knob, on either side of the gear, should fit tightly behind the ridge of the motor housing suspension arm.
5Insert the rubber coupling into the bottom of the gear and push it up into the gear until it fits tight. On models with a small white pin, first insert the pin through the rubber coupling and then push both up into the gear until it fits tight. Check that this is properly seated by spinning the fan with your hand. The teeth in the gear should slowly move in and out.
1
3
2
5
Service Option: Venta-Airwasher
In case you prefer the factory to handle your concern, for warranty repair, or if you wish to utilize the factory cleaning service for your
15