Before First Use
1Place the unit upright on a firm, flat surface. For proper air circulation make sure the vented sides are at least
2Inspect the power cord to insure it is free of damages.
3Make sure the upper housing is removed from the lower housing.
4Place disk stack(s) into lower housing.
5Add fresh tap water. Fill water to the fill line located approximately one (1) inch below the top on the inside of the lower housing. You can transport the lower housing to your sink or tub – or you may fill the lower housing by carrying the
water in a pitcher or watering can to the lower housing. Be careful when filling, cleaning, or moving the
Venta through the air intake holes on top of the upper housing.
6Add 3.5 fl.oz. of Venta WTA, the contents of one sample bottle.
For your convenience two (2) starter bottles of Venta WTA are enclosed.
UPPER HOUSING
DISK STACK
LOWER HOUSING
7Place upper housing properly on top of lower housing.
8Plug power cord into standard
9See “Daily Use and Operation” on page 6.
5