Network Camera User’s Guide
Appendix A: Restore Factory Default Settings
There is a button hidden in the pinhole above the Alarm I/O connector. It is used to restore the factory default settings. Sometimes restarting the Network Camera will make the system back to a normal state. If the system still got problems after reset, user can restore the factory default settings and install it again.
Restore the Network Camera:
1.Power off the Network Camera.
2.Insert the paper clip or other tool and press and hold the button down continuously.
3.Power on the Network Camera again.
4.Wait at least 8 seconds and release the tool. Then the Network Camera has been restored to default settings.
5.
Note: Restoring the factory default setting will lose the all previous settings forever. User needs to run the IP Finder program to search the Network Camera and configure it to let the Network Camera work properly again.
76/95
