VeriFone 1000SE manual Screw-Mounting the Adapter Using the Stand

SETUP

Use Stand Adapter

Screw-Mounting the Adapter

Using the Stand

Adapter

The stand adapter may also be screwed directly to a wall or countertop.

•Use screw anchors when fastening the adapter to a cement or brick wall.

•When fastening the plate to drywall, the screws must go into the studs behind the wall. Screw anchors alone will not safely hold the adapter to drywall.

To screw-mount the stand adaptor, use American National Standard #8 or Metric M3 screws, with head diameter between 4.5 and 6.0mm, and head thickness less than 2.5mm. Use the stand adaptor to mark the hole placement on the desired location, and then insert screws, adjust the screw depth until the unit is firmly mounted.

Figure 6 shows how to insert a PINpad 1000SE unit into a stand adapter. Slide the end of the PINpad 1000SE unit into the bottom of the stand adapter, then press the screen end of the PINpad 1000SE unit firmly into the top of the stand adapter until you hear and feel the release lever click.

Figure 6 Inserting the PINpad 1000SE device into the Stand Adapter

Removal is simply the reverse: press the release lever at the top of the stand adapter and pull the PINpad 1000SE unit up and out of the stand adapter.

14PINPAD 1000SE INSTALLATION GUIDE