Assembly Instructions
Read Instructions Carefully Before
Assembly:
1. Remove lamp from box and packaging.
Remove red plastic protective pieces from lamp shaft. NOTE: Please save original packaging for repacking should you need to return the product.
2. Set lamp base on the floor and insert the lamp shaft over the base support part until the screw holes line up as shown in Fig.1. Insert the screw using the tightening tool and turn clockwise to tighten.
3.Attach the lamp head gooseneck to the shaft, tucking the wire into the shaft, until the screw holes line up as shown in Fig.1. Insert the screw using the tightening tool and turn clockwise to tighten. Should you have difficulty lining up the base or head screw holes, refer to the troubleshooting section of this manual.
in the lamp base
Fig. 1
Assembly Instructions (continued)
4. Attaching the Parabolic Grid Diffuser
• Remove grid diffuser from protective plastic bag
• Insert plastic pegs at bottom of grid diffuser into openings near bulb socket
• Snap tab into place
5. Plug lamp into outlet and turn on; if bulb does not illuminate instantly, please refer to the troubleshooting section of this manual.
DO lift your lamp by the shaft | DO NOT lift the lamp by |
| the gooseneck |
5 | 6 |
