Vermont Castings, Majestic Products DEF/DEFD26
Operating Instructions
NOTE: The control compartment is located behind the upper louvre panel. To access controls, flip the upper louvre panel down.
3 | 2 | 1 | 5 | 4 |
|
|
|
| 10005754 |
Fig. 3 Control locations behind upper louvre panel.
1. Main ON/OFF Switch
The ON/OFF switch supplies power to all functions of the fireplace. This is an illuminated switch which normally lights up when in the ON or OFF position.
2. Heater Control
The Heater Control acts to turn the heater ON and OFF as well as setting the comfort level in the room. Turning the knob clockwise from the OFF position will place the heater into operation. The further the knob is rotated clockwise, the higher the setpoint temperature. Turning the knob counterclockwise will lower the setpoint temperature. Turning it all the way counterclockwise will turn the heater function OFF.
WARNING: During any service of this appliance, the power to the unit must be turned OFF. It is not acceptable to use the ON/OFF switch to meet this requirement.
3. Flame Speed Control
Turn the flame speed control knob to increase or decrease the flame speed as desired.
4. Re-learn
This model fireplace with integral remote control has a preprogrammed,
1.Be sure there is power to the fireplace.
2.Be sure there is a good battery in the Transmitter
3.Open the battery compartment of the remote.
4.Press and release the small button located in the top left corner. This will randomly select a new house code in the remote Transmitter.
5.Close the remote Transmitter battery compartment.
6.Press either the ON or OFF button on the remote Transmitter, and the Learn button on the fireplace at the same time. The fireplace is now ready to accept commands from the remote Transmitter.
5. ON/OFF
The ON/OFF button on the fireplace (below the Learn button) is to turn the fireplace ON and OFF when the battery in remote Transmitter is weak, or to manually operate the fireplace without the remote Transmitter.
NOTE: The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.This device must accept any interference received, including interference that may cause undesired operation.
10005581 | 9 |