Vermont Casting TBREF36 manual Service Instructions, Screen Kit Installation, Maintenance of Motor

TBREF Electric Fireplace

Screen Kit Installation

1. Remove the plastic bag from each screen. (Clip)

2. Remove the four (4) metal clips, two (2) for each side of the fireplace opening.

3. Slide screen panels against sides of the fireplace opening.

4.Align each metal clip with the hole it was removed from, while at the same time, hooking the clip through the last wire of the screen. Snap clips into

place. (Fig. 5)

5. Pull screens back and forth to ensure they work	FP1041
freely.
	Clip installation.
Fig. 5

Service Instructions

To reduce the risk of fire, electrical shock or personal injury, disconnect all power coming to the fireplace at the main service panel before attempting any maintenance or cleaning.

Maintenance of Motor

The motors used on the fan and the drum assemblies are prelubricated for extended bearing life, and require no further lubrication. However, periodic cleaning/vacu- uming of the fan/ heater is recommended.

Replacing Light Bulbs

This fireplace uses four (4) clear, 120 Volt, 60 Watt, E-12 socket base (small base, chandelier candle-type) light bulbs. These lights are located under the ember bed of the unit.

Do not exceed 60 Watts per bulb. Use of higher-rated bulbs may result in fire, caus- ing property damage, personal injury, or loss of life.

NOTE: For the sake of convenience, you may wish to consider replacing all the light bulbs if one of them burns out.

1.Turn OFF the power to the unit at the main service panel.

2.If the fireplace has been operating, allow it to cool.

3.Open glass (if applicable); open steel curtain.

4.Remove the four (4) screws securing the ember bed in position. Two (2) screws are located on either side of the ember bed near the front and rear.

5.Examine the bulbs to determine which one(s) need to be replaced (if you are not going to replace all).

7.Install new light bulb(s) by screwing in while holding the socket.

8.Reinstall the ember bed, log set, glass door, and steel curtain.

Cleaning Trim

Clean the trim using a soft cloth you have slightly damp- ened with lemon oil; then buff with a clean soft cloth.

NOTE:You can obtain lemon oil at super-markets and hardware stores. Do not use commercially made brass polish or household cleaners, as these products will damage the trim.

10007572 9