Operation
Lighting the Main Burners
WARNING | NOTICE: When lighting the grill for the first time, burn with the | |
main burners on HIGH for at least 30 minutes, to burn off any | ||
Never stand directly over the Grill when lighting the main burn- | manufacturing residues. | |
Figure 8 | ||
ers, to avoid exposure to possible | ||
|
1. Always open the Hood completely and always inspect the Grill and burners before lighting the main burners.
2. Always confirm that all of the burner control knobs are in the OFF position before opening the gas supply.
3. Turn on the Propane Tank Valve at the tank (1 to 2 turns) (Fig. 8)or turn on the main natural gas supply valve.
4. Turn the selected Burner Control Knob to the HIGH posi- tion by pushing down on the knob and turning it counter- clockwise.
5. Immediately activate the Igniter. (Refer to Page 6) The selected burner should light within five seconds. Light the burners sequentially from either left to right or right to left.
IF THE SELECTED BURNER DOES NOT LIGHT, |
|
immediately turn the burner control knob to the OFF posi- |
|
tion, to prevent gas buildup. Wait five (5) minutes for the gas to | B220 |
clear and then repeat the preceding |
|
starting procedure. If the burner will not light when using the Igniter, follow the match lighting instructions. |
|
(Refer to Page 8) |
|
6.Confirm that the burner is properly lit and the flame pattern is as desired. Refer to Figures 9a, 9b & 9c, for the proper flame patterns. If the flame pattern is other than normal, consult the Troubleshooting Guide on Page 23 for corrective action.
7.Always preheat the grill before starting cooking. A light coating of cooking oil on the cooking grids, before heating the Grill, will prevent foods from sticking to the Grill. Light all burners and adjust them to the HIGH position for 5 to 10 minutes. Before placing any food on the Grill, clean the cooking grids with a brass wire brush.
8.Adjust the Controls to a medium setting for most cooking requirements.
Figure 9a
Figure 9b
Figure 9c
B129
Normal: Soft blue flames | Out of Adjustment: Noisy, hard blue |
| flames indicate too much air |
Poor Combustion: Wavy, yellow flames indicate too little air.
Page 7
50004581
