Verona VEFSEE 244 P warranty Electrical Requirements, Electrical Connection with Power Cord

 electrical connection

WARNING

TO AVOID ELECTRICAL SHOCK HAZARD, BEFORE INSTALLING THE APPLIANCE, SWITCH POWER OFF AT THE SERVICE PANEL AND LOCK THE PANEL TO PREVENT THE POWER F R O M B E I N G S W I T C H E D O N ACCIDENTALLY.

ELECTRICAL REQUIREMENTS

•This appliance must be properly installed and grounded by a qualified technician in accordance with the National Electrical Code ANSI/NFPA No.70 (latest edition) and local electrical code requirements. IN CANADA: Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical Codes Part1 and/or local codes.

•This appliance may be connected by means of permanent “Hard Wiring” or “Power Supply Cord Kit”. Power supply cord is not supplied, but it is available through your local electric supply house.

•Use only 3-conductor or 4-conductor CSA/UL listed range cord rated at 55 amps with 250 V minimum and provided with ring terminals. These cords should be pro- vided with strain relief or conduit connector.

Warning: Frame grounded through neutral lead. If used in,

-New branch-circuit installations (1996 NEC),

-Mobile homes,

-Recreational vehicles, or

-In an area where local codes prohibit grounding through neutral, use a 4 conductor cord or conduit.

•The range must be connected to the proper electrical voltage and frequency as specified on the rating plate.

•The range can be connected directly to the fused disconnect (or circuit breaker box) through flexible, armoured or non-metallic sheathed, copper cable (with grounding wire). Allow two to three feet of slack in the line so that it can be moved if servicing is ever necessary.

ELECTRICAL CONNECTION WITH POWER CORD

Use a 3-wire power supply cord kit rated for 55 amps - 125/250 Volts with closed loop terminals and marked for use with ranges. Where local codes do not permit grounding through neutral, use a 4-wire power supply cord kit.

The cord or CSA/UL-listed conduit must be secured to the range with the strain relief supplied or with a suitable strain relief. The electrical connection is made at the terminal block, which is located behind the access door on the back of the range.

ELECTRICAL CONNECTION WITH CONDUIT

Use 3/4” (1.90 cm) trade size conduit with a conduit clamp, 10 AWG/600 Volt cop- per conductor colored red for line 1 and black for line 2 and 12 AWG/600 Volt copper conductor (or 10 AWG/600 Volt copper conductor if grounding through neutral) colored white for neutral with closed loop terminals marked for use with ranges.

Where local codes do not permit grounding through neutral, use a green 10 AWG copper conductor as directed in the 4-wire connector directions. The conduit must be secured to the range with the strain relief bracket. The electrical connection is made at the terminal block which is located behind the access door on the back of the range.

8