
3-Wire Flat Power Cord Installation
(See Figures 2.1 and 2.2)
1. | Remove the Terminal Block Access Plate on the back of the |
| range by unscrewing the 4 fixing Screws. |
2. | Insert the Flat Power Cord through the Bracket; then |
| tighten the Flat Power Cord by using the Strain Relief. |
| Allow enough slack to easily attach the cord terminals to the |
| Terminal Block. |
3. | Remove the 3 wire terminal nuts and washers from the |
| Terminal Block. |
4. | Plug the terminal holes of Flat Power Cord. The Neutral or |
| Ground Wire of the Flat Power Cord must be connected to |
| the neutral terminal located in the center of Terminal Block. |
| The Power Wires must be connected to the outside termi- |
| nals. |
5. | Plug washers and tighten nuts securely. |
| |
Screws | Fig. 2.1 |
| |
Terminal Block |
|
Access Plate |
|
Do not remove Ground strap. |
6. Assemble the Terminal Block Access Plate. |
Neutral Wire
Power Wires
Bracket
Strain Relief
Fig. 2.2
Terminal Block
Ground strap
Flat |
Power Cord |
9