| cleaning and maintenance | |
|
|
|
WARNING
Electrical Shock Hazard
Plug into a grounded
Do not remove ground prong. Do not use an adapter.
Failure to follow these instructions can result in death, fire, or electrical shock.
ground
prong
GENERAL RECOMANDATION
✓Important: Before any operation of cleaning and maintenance disconnect the appliance from the electrical supply.
✓It is advisable to clean when the appliance is cold and especially for cleaning the enamelled parts.
✓Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the sur- faces.
✓Avoid using cleaning products with a chlorine or acidic base.
WARNING
When correctly installed, your product meets all safety requirements laid down for this type of product category. However special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges, that may cause injury.
ENAMELLED PARTS
✓All the enamelled parts must be cleaned with a sponge and soapy water only or other
Dry preferably with a microfibre or soft cloth.
PAINTED PARTS AND SILK-SCREEN PRINTED SURFACES
✓Clean using an appropriate product. Always dry thoroughly.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abra- sion. You are advised to use a soft cloth and neutral soap.
STAINLESS STEEL ELEMENTS
✓Stainless steel parts must be rinsed with water and dried with a soft and clean cloth.
✓For difficult dirt, use a specific
✓Note: regular use could cause discolouring around the burners, because of the high flame temperature.
INSIDE OF OVEN
The oven should always be cleaned after use when it has cooled down.
The cavity should be cleaned using a mild detergent solution and warm water.
Suitable proprietary chemical cleaners may be used after first consulting with the manufacturers recommendations and testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface.
NOTE: The manufacturers of this appliance will accept no responsibility for damage caused by chemical or abrasive cleaning.
Let the oven cool down and pay special attention no to touch the hot heating elements inside the oven cavity.
WARNING
VERY IMPORTANT
Before any operation of maintenance disconnect the appliance from the electrical mains supply.
Do not use steam jet cleaners because the humidity could infiltrate into the appliance making
18it dangerous.
REPLACING THE OVEN LIGHT
Before any maintenance is started involving electrical parts of the appliance, it must be disconnected from the power supply.
✓Let the oven cavity and the broil burner cool down;
✓Switch off the electrical supply;
✓Remove the protective cover;
✓Unscrew and replace the bulb with a new one suitable for high temperatures (300°C- 570°F) having the following specifications: 120V 60 Hz, 15W, E14;
✓Refit the protective cover.
NOTE: Oven bulb replacement is not covered by your guarantee.
